Here's a quick tip on welding exhaust tubing with your MIG welder... do it HOT and FAST! This technique shows how to burn deep-penetrating, low-profile welds that look great on their own or can be easily dressed for polishing or coating. The secret is to use high amperage (or heat) and a series of quick tack welds, and give the work time to cool between each tack! Resist the urge to seam-weld the whole tube... you'll have to run your welder too "cold" to prevent burn through, resulting in welds that are stacked high on the tubing, not only looking poorly, but also not penetrating as deep as you'd like.

 

It's easy to test old fixtures before installing them.

 

http://www.usaweld.com - Setting the proper wire speed and heat settings is easy if you know how to do it. This video will show you the fastest and easiest way to dial-in your MIG welder properly.

 

Sometimes you need hardware store grade nuts and bolts for your project, and they often times come with colored dye on them. This stuff can be a pain and a time killer to remove, but we found that Eastwood Fast Etch zaps it off quickly.

 

Racers have been punching holes in panels to reduce weight for years, and when you punch a flared hole, you actually add strength while reducing weight. In this short video, we show you how to punch flat and flared holes using a flared hole punch set from Mittler Brothers (http://www.mittlerbros.com) to create these holes quickly and easily.